Samsung Embedded WebServer (EWS) Integration Guide

Deprecation Notice

This method of integrating with Samsung devices is intended for deprecation. Please see the Multiple Display Control (MDC) documentation for the currently used integration method.

This document serves as a comprehensive guide that outlines the steps required to integrate Samsung displays with the NetSpeek platform using Samsung’s EWS (Embedded WebServer) protocol.

Please note that there are two methods of integrating Samsung displays, and different displays have different configurations. This guide describes the Embedded WebServer method which is planned for deprecation – the other method, called MDC (for Multiple Display Control), is described here.

Enabling Embedded WebServer for Samsung Displays

Prerequisites

Before beginning the integration, confirm the following:

Your Samsung display is powered on and connected to a network that is routable to/from your NetSpeek Edge.
You have deployed a NetSpeek Edge VM as described here: https://docs.netspeek.ai/netspeek-edge-installation-guide/
Administrator access to the display settings.

Step 1. Enable the Embedded WebServer on the Display

On your Samsung display, using the remote control, navigate in the on-screen TV user interface to:
Settings > Network > Embedded Server
Toggle the Embedded Server setting to ON

This enables remote configuration access via web browser.

Step 2. Access the Samsung Display’s Web Interface

On a computer connected to the same local network as the display, open your browser and go to:

https://<device-ip>:4000/

Replace <device-ip> with the actual IP address of your Samsung display, for example: https://192.168.1.25:4000

Note

If this is your first time accessing the web interface, the system will prompt you to create a username and password. Please store these credentials securely — you will need them for API integration with NetSpeek.

Step 3. Create Username and Password, or Log In to the Web Interface

If visiting for the first time:
- You’ll be prompted to create a new username and password
If you’ve previously set up credentials:
- Use your existing username and password to log in

Step 4. Provide Credentials for NetSpeek Integration

Once you’ve created or verified your credentials, input them within the NetSpeek Room Canvas when adding the display to a room.

Verification

Once the relevant settings described above are configured, to validate the integration:

Select a Samsung device in the NetSpeek console, open the Device Actions Tab, and select an available device action. It is generally advisable to test by dispatching a non-intrusive command such as a Get Status.
On the device, observe the selected action occurring.

Support

If you run into any issues during onboarding or have questions, contact NetSpeek Support at support@netspeek.com.